Game ready Med4 Elite Guia De Inicio Rapido

QUICK START
WELCOME TO MED4 ELITE
The Med4 Elite is a multi-modality recovery device for
professional users. The system delivers iceless cold therapy,
heat therapy, rapid contrast (alternating heat and cold)
therapy, and intermittent pneumatic compression therapy
providing healthcare practitioners with flexible treatment
options for different patients, procedures, injuries and stages
of rehabilitation.
1
START HERE
WARNING: It is mandatory to fully read and
understand the User Manual before using the
device. Failure to follow operating instructions
could result in serious injury
IMPORTANT: Read complete indications,
contraindications, cautions, and warnings
before using this product
Use distilled water only. DO NOT use
deionized or tap water. Failure to use distilled
water may void the warranty of the device.
SETTING UP
Use the handles to move the Control Unit into place.
The Control Unit should be set up:
• within six feet of a power outlet with a dedicated
electrical circuit or enough power to supply 1200 watts
• with adequate access to the On/Off Switch on the back
of the unit and with the power cord unobstructed
• on level ground
• indoors only
• in a dry location
• so that vents on all sides are unobstructed
• free of trip hazards
Once the device is located in a suitable location,
lock the casters in place by pressing down on all
four caster locks until they click into the down and
locked position.
Game Ready Technical Support: 1.888.426.3732
2A 2B
PUSH TO OPEN LIFT COVER
To prevent damage to your Control Unit, you must
fill the reservoirs with distilled water BEFORE
turning it on. If the Control Unit is turned on without
water, or with an insufficient amount of water, you
will be prompted to add water before continuing.
3B
3A
BACK OF CONTROL UNIT
4A REMOVE POWER ON
4B
THE PROTECTIVE THE UNIT
FILM
2
DISTILLED
WATER
FILL RESERVOIRS
The Med4 Elite ships with the reservoirs empty. You
will need to fill the reservoirs prior to use. Two gallons
(eight liters) of distilled water are needed to completely
fill the reservoirs.
When finished filling the reservoirs, close the cover.
Press firmly to engage the latch.
3
POWERING UP
After you have successfully filled the reservoirs, attach
the power cord to the back of the Control Unit and plug
the power cord into the appropriate power outlet. (3A)
Turn on the power located on the back of the Control
Unit. (3B)
4
ON/OFF
After you switch the power on, remove the protective
film and discard. (4A) Press the amber On/Off button.
The Med4 Elite operating system takes up to 60
seconds to load. (4B)
5
SELECT LANGUAGE
On the initial boot, the Select Language screen appears.
Press the up or down arrows to scroll through the available
languages. Follow the on screen prompts to confirm.
A