Package Contents; Overview (Fig. A) - Black and Decker CD701 Manual De Instrucciones

E N G L I S H
Mains plug replacement
(U.K. & Ireland only)
Should your mains plug need replacing and
you are competent to do this, proceed as
instructed below. If you are in doubt, contact
an authorised repair agent or a qualified
electrician.
Disconnect the plug from the supply and
remove the fuse from the plug.
Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective
points in the plug (see above). Brown is for
Live (L) (2), blue is for Neutral (N) (4) and
green/yellow is for Earth (E).
The earth wire should be of a length to ensure
that in the event of the cable being pulled
from the plug, the earth wire is the last to
break contact.
Before replacing the top cover of the mains
plug ensure that the cable restraint (3)
is holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
If the plug has a fuse cover, make sure that the
fuse cover is fitted. Do not use the plug if the
fuse cover is missing or damaged.
Never use a light socket.
8
Using an extension cable
Always use an approved 3-core extension cable
suitable for the power input of this tool (see
technical data). When using a cable reel, always
unwind the cable completely.

PACKAGE CONTENTS

The package contains:
1 Heatgun
1 Instruction manual
Carefully unpack all parts.

OVERVIEW (fig. A)

1. On/off switch
2. Nozzle
3. Ventilation slots
4. Hanging hook
USE
Use only one hand to hold the tool.
Do not place your other hand over the
ventilation slots (fig. B).
Switching on and off (fig. C)
To switch the tool on at the low temperature
setting, set the on/off switch (1) to position I.
To switch the tool on at the high temperature
setting, set the on/off switch (1) to position II.
To switch the tool off, set the on/off switch to
position 0.
The nozzle will remain hot for some time
after switching off. After switching off,
suspend the tool on the hanging hook as
shown in fig. E or place it on a table as
shown in fig. D.
Stripping paint
Switch the tool on at the high temperature
setting.
Direct the hot air onto the paint to be
removed.
When the paint softens, scrape the paint away
using a hand scraper.