DeWalt DCB116 Manual De Instrucciones página 6

terminals are protected and well insulated from materials that could
contact them and cause a short circuit.
SPECIFIC SAFETY INSTRUCTIONS FOR LITHIUM ION
(Li-Ion)
• Do not incinerate the battery pack even if it is severely
damaged or is completely worn out. The battery pack can
explode in a fire. Toxic fumes and materials are created when
lithium ion battery packs are burned.
• If battery contents come into contact with the skin,
immediately wash area with mild soap and water. If battery
liquid gets into the eye, rinse water over the open eye for 15
minutes or until irritation ceases. If medical attention is needed,
the battery electrolyte is composed of a mixture of liquid organic
carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory
irritation. Provide fresh air. If symptoms persists, seek medical
attention.
WARNING: Burn hazard. Battery liquid may be flammable if
exposed to spark or flame.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling
Corp oration) Seal on the nickel cadmium, nickel metal
hydride or lithium ion batteries (or battery packs)
indicate that the costs to recycle these batteries
(or battery packs) at the end of their useful life have
already been paid by D WALT. In some areas, it is illegal to place
e
spent nickel cadmium, nickel metal hydride or lithium ion batteries
in the trash or municipal solid waste stream and the RBRC program
provides an environmentally conscious alternative.
RBRC™, in cooperation with D
established programs in the United States and Canada to facilitate
the collection of spent nickel cadmium, nickel metal hydride or
lithium ion batteries. Help protect our environment and conserve
natural resources by returning the spent nickel cadmium, nickel
metal hydride or lithium ion batteries to an authorized D
service center or to your local retailer for recycling. You may also
contact your local recycling center for information on where to drop
off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery
Recycling Corporation.
Chargers
Be sure to read all safety instructions before using your charger.
Consult the chart at the end of this manual for compatibility of
chargers and battery packs.
CAUTION: Do not use as a step. Stepping on the charger may
result in personal injury or damage to the charger.
Charging Procedure (Fig. 1, 3)
1. Plug the charger into an
appropriate outlet
inserting the battery packs.
2. Unhook the locking latches (b) and
lift the lid (a) of the charger.
3. Insert the battery packs (k) into
any of the six battery ports (c), as
shown in Figure 3, making sure
the packs are fully seated in the
charger.
4. Close the lid and fasten the
locking latches. Batteries will only
charge when the lid is fully latched. The red LED (d) next to its
4
WALT and other battery users, has
e
FIG. 3
before
WALT
e