Resfriar RES67GE Manual Del Propietário página 38

For the perfect operation of the refrigerator, the installation of the power network must obey the following criteria:
• Observe the polarity indicated on the electric wiring (positive and negative). The red color refers to the positive and the black color
refers to the negative. In case you plug the inverted wires the fuse will burn out and replacement will be needed. Use the exclusive
connectors to plug the refrigerator to the battery (RES67GE).
It's recommended to observe the following spaces while making the installation:
• Back: 15cm from the chassis frame
• Upper: 10cm
• Lateral: 10cm
• Make sure to leave some free space for the air circulation on the sides for the refrigerator and in the back for the compressor.
• Unplug the refrigerator from the power supply if welding any item, to avoid compromising its operation.
• The refrigerator cooling system operates with ecological refrigerant R134a.
• For safety reasons you must wait for at least 30 seconds to switch the compressor from 12V voltage to 24V and so on.
• The electric wire length available for the electrical installation is 300mm.
• The fuse should be connected in series with the positive wire, which is in the inner compartment next to the compressor.
-
Use a 15A fuse
38
Resfri Ar refrigerator power supply
Master
Switch
+
Vehicle
Battery
Wire gauge definition table according to
the power supply voltage and its length:
Cross
2 Black (-)
Section
1 Red (+)
[mm2]
2,5
4
6
10
Maximum
Maximum
Lenght when
Lenght when
in 12V
in 24V
[m] [m]
2,5 5
4 8
6 12
10 20