TomTom Remote LINK Manual Del Usuario página 3

Borna_WorkingTime.book Page 4 Thursday, January 21, 2010 9:54 AM
EN
Preparing your Remote LINK
Remote LINK starts searching for your LINK 300/310 and
the Connection LED begins to flash rapidly. Searching may
take about one minute before a connection is established.
Note: To check if a connection has been established press any
key. If a connection has been established, the Connection LED
will be on. If you do not use your Remote LINK for more than
10 seconds it will turn off.
If no connection was established the LED will switch off.
To establish a connection, repeat steps 1 to 4 or visit
www.tomtomwork.com/connect-remotelink for alternative
connection methods.
Reset your Remote LINK
If your Remote LINK is already paired but does not work
correctly or it is paired with the wrong device, you can reset
the Remote LINK to the default factory settings.
1. Press any key to switch on the device.
2. Press any two buttons at the same time until you hear a
sound.
Your Remote LINK switches off. To pair the device with the
LINK 300/310, read and follow the instructions under
'Establishing a paired connection'.
4