Elnur Gabarron THMEAMT1 Guía Rápida página 37

1 ) Use straight head screwdriver to insert in the buckling position in the
bottom of wired controller, and spin the screwdriver to take down the back
cover. (Pay attention to spinning direction, otherwise will damage the back
cover!)
2) Use three M4X20 screws to directly install the back cover on the wall.
3) Use two M4X25 screws to install the back cover on the 86 electrician
box, and use one M4X20 screws for fixing on the wall.
4) Adjust the length of two plastic screw bars in the accessory to be
standard length from the electrical box screw bar to the wall. Make sure
while installing the screw bar to the wall, making it as flat as the wall.
5) Use cross head screws to fix the wired controller bottom cover in the wall
through the screw bar. Make sure the wired controller bottom cover is on
the same level after installation, and then install the wired controller back to
the bottom cover.
6) Over fastening the screw will lead to deforma tion of back cover.
A
Cutting place of left
down side wire outlet
Left down
side wire
outlet
34