Makita HB350 Manual Del Usuario página 6

WARNING!
Always use safety chain. Moun�ng can release.
. MAINTENANCE
• Occasionally apply a few drops
of oil to the rack toothing.
• The bearings of the feed sha�
are self- lubrica�ng and must not
be greased.
• Grease the sliding surface of the
carriage with MOLYCOTE grease.
• When not in use or being
transported the unit should be kept
in the case supplied.
• A�er use ensure unit is clean of
swarf and dirt.
• Parts that are worn or damaged
should be replaced immediately
with genuine
replacements.
• Ensure all cu�ng edges are
sharp when in opera�on. Using
blunt cu�ng tools may lead to an
IMPORTANT! – TO PREVENT DAMAGE TO THE CIRCUITRY, NEVER USE
ELECTROMAGNETIC DRILLING MACHINES AND WELDING EQUIPMENT ON THE SAME
WORKPIECE SIMULTANEOUSLY.
Op�onal Accessories
For details of op�ons, either refer to the catalog or inquire at the store of
purchase or a Makita sales office.
If you need any assistance for more details regarding these accessories, ask your local
Makita Service Center.
• HSS Cu�er
• TCT Cu�er
• Drill chuck
manufacturer's
overload of the motor.
• A�er every 30 minutes running, it is
recommended that the machine is laid on
its side to permit grease to run across the
gear train.
• A�er repeated use, the cradle may
become loose. This is remedied by
adjus�ng the tension screws on the side
of the body. Put 2.5mm hex wrench into
head of cradle retaining nuts, using 8mm
Spanner undo the locking nuts an�-
clockwise, holding the hex wrench without
moving grub screws.
Using the hex wrench gently �ghten
screws in series un�l the cradle moves
freely in the slide but does not allow the
motor to wobble.
When adjustment is complete re-
�ghten locking nuts clockwise, ensuring
the grub screws do not move from their
new posi�on
EN