Publicidad
Idiomas disponibles
Idiomas disponibles
Removal of motor:
• Close shutter completely.
• Cut motor off from power supply, if necessary remove light sensor
from window
• Remove screw cover from front of control panel and unscrew both
of the unlosable screws. Lift control panel off.
• Now remove both of the fastening screws of the flush mount coiler
using a screw driver and extract coiler from out of the wall.
• Loosen the fastening screw of the strap spool holder. Slowly remove
strap spool and take the sleeve out from the centre of the spool.
• Now remove the strap from the spool and pull it out of the flush
mount coiler.
Available accessories:
If necessary a shutter strap coiler can be used with a strap length of up to 10m. The large strap spool
Nº 041AGW10 with a diameter of 14.5cm will be necessary. Please be aware that the shutter strap
coiler equipped with this strap spool only fits into the flush mount strap box which has a distance
between screws of 185mm. Therefore check existing installation.
Technical data:
Item Nº: GWUP180
Supply voltage: 230V AC / 50Hz
Operating voltage: 24V
Pulling force approx. 18kg / 180N
Torque: 1.8Nm
Operating power: max 60W
Standby: <0.2W
Strap width: >23mm
Strap capacity approx. 4.5m with strap thickness of 1.3mm (approx. 10m with available large strap
spool)
Short time rating: max 5min
Protection class II (only use in dry areas)
Power cable H05 VV-F 2 x 0.75
Material recyclable
Tested according to EN 60335
Certificates LGA/GS, CE
709156-1GB
Publicidad
