Volume Control; Problems And Troubleshooting; Important - Emtec Universal EKCOH420 Manual Del Usuario

2. Press the mode key (9) for the equipment you want to identify (TV or AUX). The LED blinks once.
3, Press again S. The LED blinks once.
4, To identify the first digit press each number button from 0 – 9 (12) until the LED blinks. The number you
pressed is the first digit of the code.
5. Press each number key from 0 – 9 as above to find the second and third digit.
6, Press each number key from 0 – 9 as above to find the fourth digit. When the fourth digit has been found the
LED will go off. Don't forget to write down the code on the label of the battery compartment.

8) Volume Control

Adjustment of ALL volume controls under a specific mode
You can program the remote control so that the volume and mute keys control a specific device (the volume
control must exist on the corresponding device). E.g. control of TV sound in TV mode and AUX mode.
1. Press and hold S (2) until the LED indicator (1) lights steadily. Release S.
2. Press and hold MUTE (4) until the LED (1) blinks once. Release MUTE.
3. Press once on the mode key (TV or AUX) corresponding to the device whose volume will always be
controlled by the VOL (7) and MUTE (4) keys.
4. Press the MUTE (4) key once.
Adjustment of the volume controls for EACH mode.
You can program the remote control so that the volume control is functional for each mode selected (the volume
control must exist on the corresponding device). E.g. control of the television set sound in TV mode, control of
the sound of the appliance programmed under the AUX button in AUX mode.
1. Press and hold S (2) until the LED indicator (1) lights steadily. Release S.
2. Press and hold MUTE (4) until the LED (1) blinks once. Release MUTE.
3. Press once on the mode key (TV, AUX) corresponding to the device whose volume will always be controlled
by the VOL (7) and MUTE (4) keys.
4. Press the VOL-(7) key once.
5. Press the MUTE (4) key once.

9) Problems and troubleshooting

The remote doesn't work or loses codes entered
Confirm with your original remote that the equipment works correctly.
Make sure that you have pressed the corresponding mode key of the equipment or device that you want to
control.
If the listed code does not work , try the AUTOSEARCH method or enter the next code of that brand.
To find the corresponding code for your equipment use the automatic search.
Check that the batteries have the correct polarity position.
The programming of the remote requires 2 CR2032 batteries (new). If the remote loses codes within a few
days/weeks the problem can be solved by using  new batteries from the same brand.
If the LED is lit permanently, in general it will be necessary to replace the batteries.

Important:

The  in  Universal Remote Control must be used only in the way described in this instruction manual and may
not be used for a purpose not intended.
5