Original Instructions "Biscuit Jointer; Symbols And Abbreviations; Safety Rules; General Safety Instructions For Power Tools - KRESS 800 FDF Manual Original

Original instructions "Biscuit Jointer"

Symbols and abbreviations

1. Symbols and abbreviations
The symbols used in these instructions and, if ap-
plicable, on the power tool serve to bring your at-
tention to potential dangers when working with
this power tool. You must understand the signifi-
cance of these symbols/notes and comply with
them in order to make its use more efficient and
safer.
The safety warnings, notes and symbols are not a
substitute for regulation measures for accident
prevention.
Symbols
Especially important note for safety.
Always follow this note, otherwise it
could result in severe injury.
Warning of dangerous electrical volt-
age
Warning of hot surfaces
-WARNING-
For a potentially dangerous situation which could
lead to physical injury or material damage.
-NOTE-
Modification notes and other useful information.

2. Safety rules

General safety instructions for power
tools
WARNING!
Read all safety warnings and all
instructions.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.
Work area
Keep work area clean and well lit.
Cluttered and dark areas invite to accidents.
Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable liq-
uids, gases or dust.
Power tools create sparks which may ignite dust
or fumes.
Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.

Electrical safety

Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapt-
er plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce
risk of electric shock.
Avoid body contact with grounded surfaces such
as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your
body is grounded.
Do not expose power tools to rain or
wet conditions.
Water entering a power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the cord for car-
rying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts.
Damaged or entangled cords increase the risk of
electric shock.
When operating a power tool outdoors, use an ex-
tension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the
risk of electric shock.
If operating a power tool in a damp location is un-
avoidable, use a residual current device (RCD)
protected supply.
Use of an RCD reduces the risk of electric shock.
Personal safety
Stay alert, watch what you are doing and use com-
mon sense when operating a power tool. Do not
English 15
EN
FDF-EN / 0802