teutonia Team Cosmo Manual De Instrucciones página 13

Adjusting the foot rest
Using the 5-point harness
Warning: Always use the crotch strap to-
gether with the waist belt.
Attaching points (D-rings) for a separate belt harness are
provided at the outer ends of the waist restraints.
Adjusting the restraints
Shoulder restraints
Waist restraints
Crotch restraints
For the lying position, lift the
foot rest and press the bar in-
to the notches.
To fold down, raise the foot
rest slightly and press the bar
out of the notch.
You can position the shoulder
harnesses at 3 levels.
Always use the position clos-
est to the shoulder level of
your child.
Open the harness by press-
ing both sides of the buckle
latches as shown in Fig. 1. It
is not necessary to separate
the chest restraints from the
waist restraints. Sit your child
in the stroller, move both its
arms through the harness
opening and insert the buck-
le latch into the crotch belt
latch.
tighten loosen
Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the
safety bar has clicked into place on both sides. To re-
move it, press the release buttons on the insert pieces.
In order to make it easier for your child to get in and out,
it suffices to release and fold up one side of the bar.
Special features of the model variations
Note: The brake should only be used to slow the wheels,
not to block them.
Warning: When reordering rear wheels, please ensure
that the supplier is aware of the deceleration brake as
the brake requires a special brake disc. The foot brake
will not function if the wrong brake disc is used!
Maintenance:
-
The brake pads can wear out during use and the brake
needs maintenance. The setting of the brake can be
done on the brake lever when the lock nut is loosened
and the adjusting bolt is unscrewed.
-
If the left and right braking effect differs, tilt over the
stroller on soft ground and adjust the bolt under the
brake housings near the wheels.
-
The bolt can be screwed and unscrewed by using an
8mm jaw wrench. Unscrewing the bolt increases the
braking effect. The setting has to be made so that the
braking effect is the same on both wheels.
TEAM COSMO
Models with deceleration
brake:
You are able to control the de-
celeration brake using the
brake on the handlebar. The
braking action can be fine-
tuned using the adjustment
screw on the brake lever.
INT
13