Listening To An External Audio Source; Care And Maintenance - Lenco ID-2 Manual Del Usuario

Listening To An External Audio Source

1. Connect the audio cable with 3.5 mm stereo plug to the AUX IN Jack
located at rear of the unit.
2. Connect the other end of the cable to a Line Out Jack or Headphone Jack
of your external audio device.
3. Turn on the external audio device.
4. The volume level can now be controlled through the main unit. Operate all
other functions on the auxiliary device as usual.
Note:
(1) If you connected the Line Out Jack of your external device then you only
need to adjust the volume control of this unit. If you connected the
Headphone Jack of your external device then you may need to adjust both
the volume control of your external device and the volume control of this
unit to find the most desirable volume setting.
(2) Press the POWER button turning off the unit when you finish listening.
Don't forget to switch off the power of your external device as well.
Audio Line Out
The unit provides an audio output source for the connection with an
other audio device. The Stereo audio LINE OUT Jacks (L&R)
located at rear of the unit.
9

Care and Maintenance

- Do not subject the unit to excessive force, shock, dust or extreme
temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent should
never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical
noise such as fluorescent lamps or motors.
Specifications
Power Supply
Power Input:
Power consumption:
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE
SET ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
If at any time in the future you should need to dispose of this
product please note that: Waste electrical products should not be
disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling
advice. (Waste Electrical and Electronic Equipment Directive)
AC 230V ~ 50Hz
13.5W Max
10