Cleaning And Maintenance - Bertazzoni F60 Serie Manual De Instrucciones

Safety when using the pyrolytic cleaning cycle
Before the cleaning cycle starts you must:
•
CAUTION: Remove all accessories and dish-
es from the oven, including the shelf sup-
ports and/or telescopic guide rails.
•
Clean any spillages or excess dirt, as during
the pyrolytic cleaning cycle these could ignite
and become a fire hazard.
•
Remove any dirt from the oven gasket.
•
Carefully follow the instructions for program-
ming the pyrolytic cleaning cycle.

Cleaning and Maintenance

Caution:
Disconnect the appliance from mains power
supply before any operation.
Clean the oven interior to remove traces of
grease or food, which could later give off smoke
and odours and cause stains to appear.
Normal Cleaning Procedure
for Oven Interior
•
Traces of grease or food in the oven can be
cleaned normally.
•
Use nylon brushes or sponges with warm
soapy water to clean enamelled surfaces
such as the bottom of the oven. Clean when
the oven is cold. Use oven-cleaning products
only on enamelled surfaces and always fol-
low the manufacturer's instructions.
16
During the pyrolytic cleaning process:
•
Do not leave any cloths or fabric hanging
from the oven handle or in close contact with
it.
•
For safety reasons, the hob must not be in
use while the oven is in pyrolytic mode.
•
The oven's inside light will remain off and
cannot be turned on.
•
The oven is equipped with a safety lock
mechanism that will prevent the door from
being opened during the cleaning cycle. Do
not try to open the door while the lock is acti-
vated, as the pyrolysis programme may be
halted.
Caution
Do not clean the oven interior with steam or
pressurised-water cleaning equipment. Do not
use metal scouring pads, wire brushes or any
utensil that can scratch the enamel.