Tristar AC-5521 Manual Del Usuario página 7

OPERATION
Timer setting
• Timer off: When the air conditioner is running, press the timer button,
the timer LED lamp is on, and the display will blink. Use the UP and
DOWN buttons to adjust time from 0.5h to 24h. When the set time
expires, the air conditioner turns off automatically.
• Timer on: When the air conditioner is in standby mode, press the timer
button, the timer LED lamp is on, and the display will blink. Use the UP
and DOWN buttons to adjust time from 0.5h to 24h.
• During this setting procedure, the operating modes after start can
be selected, if the cool mode is selected, the set temperature can be
adjusted simultaneously. After the set time expires, the air conditioner
starts automatically and runs in the selected operating mode.
Change of the set time
You can press TIMER once In the running process of the timer, the remain-
ing time will be displayed. Press the UP and DOWN buttons to increase/
decrease the time. If you press the TIMER button again during blinking, the
set time will be cancelled, namely timer quits.
COOL mode
!!!Attention: if the air conditioner is restarted immediately after shutdown
in the COOL mode, it will take 3 minutes before the cooling process will
start.!!!
• Press the MODE button to select the COOL mode.
• Press the UP or DOWN button to set the desired temperature in a range
of 18~30 C (64-86 F).
o o
• Press the SPEED button to select the desired fan speed.
• After selecting COOL mode, press the SLEEP button on the
remote control to enter the SLEEP mode. The speed level will turn
automatically in the lowest mode and the air conditionor will turn off
automatically in approximate 7h.
• Press the SWING button to activate the swing function.
DEHUMIDIFY mode
• Make sure the exhaust pipe is not installed.
• Press the MODE button to select the DEHUMIDIFY mode.
• Temperature and speed are not adjustable.
• Press the SWING button to activate the swing function.
FAN mode
• Press the MODE button to select the FAN mode.
• Press the SPEED button to select the desired fan speed. In this mode
press SPEED for "5 seconds" to run the internal dry function, i.e. both
upper and lower fans work simultaneously. Press SPEED for another "5s"
to cancel the internal dry function. Make sure the exhaust pipe is not
installed during this mode.
• During the fan mode the temperature is not adjustable.
• Press the SWING button to activate the swing function.
Cautions:
• When water full indication light comes on, the air conditioner will stop
work, you should drain the water like described further in the manual.
After drainage the air conditioner will start automatically.
• If your room faces the sun directly, please close the curtains.
DRAINAGE OPERATION (FIGURE 8.)
• When water full indication light comes on, the air conditioner will stop
work, you should drain the water.
• Place the air conditioner on a place where you can drain the water
directly (such as toilet or sewer).
• Unscrew the nut and pull out the plug. Install the plug and nut before
use.
Air conditioner
EN
7