Publicidad
To fire the Bolt, hook the diameter 2mm peg in the cut out in the Trigger (21)
over the cord attached to the tension arms (27).
Wind the Winch Block (17) so that it pulls the Trigger back along the Firing
Channel (4) pulling the tension arm cord with it.
Turn the Winch Block until the Trigger touches the Stop Peg (3x4mm) but do
not pull any tighter. The tension arm cord should have gone under the
Stripping Pegs (2x30mm).
Place the Bolt in the channel in front of the Trigger.
Aim the Ballista so that it can cause no harm or injury.
To fire pull the lever on the Trigger.
If the bolt does not fire very far then turn the Ratchets several more times.
14
Publicidad
