Publicidad
Idiomas disponibles
Idiomas disponibles
English
Daily reproduction of the daybreak, day, night fall, and night effects.
It allows to program the hour of activation at daybreak, the hour of activation in the night fall, and the time of the progressive
activation/ deactivation. The circuit accepts bands of Leds and
12V DC bulbs.
It does not accept LED bulbs.
Install a fuse and a switch for the protection and security as it is indicated in CE standard.
Buttons for programming
To programming the R 50, you have to use buttons present on the display. Leds located on each button indicate the function
you are doing
PROG:
Allows to accede to the programming mode
HORA = TIME:
Allows to adjust the present hour
DIA = DAY:
Allows to program the hour to activate the ramp for the daybreak
NOCHE = NIGHT:
Allows to program the hour to activate the ramp for the night fall
RAMPA = RAMP:
Allows to program the time of the ramp daybreak/night fall
1 hour/10 Min/1 Min: Allows to program hour, day, night and ramp
R50 programming
To connect the power supply. All leds will intermittently light on except: PROG.
This indicates the R 50 is not programmed.
To start the program mode, you have to press PROG during 5 seconds until led PROG intermittently lights on.
Programming: Set time
Press Hora: the Hora led lights on, with the buttons will 1Hora 10 MIN 1 Min you have to adjust the present hour. With each
pressure, the module will increase one unit, the led indicates it with a sparkle.
Example: 11 hours, 26 minutes:
Press 11 times 1 HORA, then 2 times 10 MIN, then 6 times 1 MIN
Once programmed the time, program the activation of the daybreak ramp, press DIA, the HORA led lights off and the DIA led
lights on.
Programming time for daybreak ramp activation
The DIA Led must light on, with push buttons 1Hora 10 MIN 1 Min you have to select the time for daybreak ramp activation,
each time you press, the module will increase one unit, the led will indicate it with a sparkle.
Example: time for daybreak ramp activation 07 hours, 45 minutes:
Press 7 times 1 HORA, then 4 times 10 minutes, then 5 times 1 MIN
Once programmed the hour of the beginning of the daybreak ramp, program the hour of activation night fall ramp, pressing
NOCHE, the DIA Led lights off, and NOCHE led will lights
on.
www.cebek.com
-
sat@cebek.com
R-50
3
Publicidad
