Lightbulb: Removal & Replacement; General Maintenance; Troubleshooting Guide - Dirt Devil M086020 Manual Del Propietário

LIGHTBULB: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1134
or your local auto parts store.
1.
Remove front panel.
3.
Pull bulb out of socket
to remove. Push bulb
into socket to replace.
HOW TO TRANSPORT CLEANER
Use the carrying handle on the back of the cleaner to move cleaner from room to room (See Pg. 5, #13 for location).
NOTE: Do not push cleaner forward while leaning on back casters, pull cleaner on back casters, or attempt to
lift cleaner using upper handle.
GENERAL MAINTENANCE
DEBRIS REMOVAL/POWER BRUSH TOOL
1. 2.
LOCKING RING
Rotate locking ring 180˚ and Pivot lower housing and
turn Power Brush Tool over. remove clog.
2. 2a.
Lay cleaner flat. Unscrew
the two (2) screws on
the headlight lens panel
(Diagram 2). Lift cover to
remove (Diagram 2a).
4.
Reattach headlight lens
panel and replace both
screws to secure into
place. Reattach front
panel.
3.
To reassemble, be sure tabs
are engaged. Pivot the lower
housing closed.
11
TROUBLESHOOTING GUIDE
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM POSSIBLE REASON
Cleaner won't run 1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
Cleaner won't
1. Paper bag is not opened.
pick-up or low
suction 2. Paper bag full.
3. Brushroll worn.
4. Broken or worn belt.
5. Clogged filter pad.
6. Nozzle/dirt passage clogged.
7. Carpet height setting is incorrect.
8. No paper bag.
9. Bag inlet clogged.
Dust escaping 1. Paper bag full.
from cleaner
2. Bag not installed correctly.
3. Puncture/hole in paper bag.
4. No bag in cleaner.
5. Hose not installed correctly.
Cleaner tools won't 1. Hose clogged.
pick-up
2. Bag inlet clogged.
3. Paper bag full.
4. No bag in cleaner; filter clogged.
Headlight not
1. Bulb burnt out.
working
2. Loose electrical wires.
Cleaner is difficult
1. Carpet height setting is incorrect.
to push
Belt burns or
1. Brush may be jammed with debris.
breaks
2. Brush End Caps are clogged with
debris.
3. Carpet Height Setting is incorrect.
4. Belt is broken.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
our website at www.dirtdevil.com. Costs of any transportation to and from any place of repair are to be paid by the
owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
or retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Take to service center or call 1-800-321-1134.
4. Allow cleaner to cool - Pg. 3.
1. Insert finger into hole and push paper away
from opening - Pg. 8.
2. Replace paper bag - Pg. 8.
3. Replace brushroll - Pg. 10.
4. Replace belt - Pg. 10.
5. Clean or replace filter - Pg. 8 & 9.
6. Remove base nozzle cover - Pg. 10; remove
obstruction OR remove hose - Pg. 6.
7. Set carpet height adjustment to appropriate
setting for carpet being cleaned - Pg. 7.
8. Clean filter - Pg. 8, install bag - Pg. 7.
9. Remove hose & paper bag and clean inlet -
Pg. 6 & 8.
1. Replace paper bag - Pg. 8.
2. Review paper bag installation - Pg. 8.
3. Replace paper bag - Pg. 8. Clean/Replace filter -
Pg. 8 & 9.
4. Install bag - Pg. 8, clean filter - Pg. 8 & 9.
5. Review hose installation - Pg. 6.
1. Remove hose and tools; remove obstruction -
Pg. 6.
2. Remove hose & paper bag and clean inlet -
Pg. 6 & 8.
3. Replace paper bag - Pg. 8.
4. Install paper bag - Pg. 8, clean filter - Pg. 8 & 9.
1. Replace bulb - Pg. 11.
2. Call 1-800-321-1134 for nearest authorized
Royal ® Dealer.
1. Set carpet height adjust lever to appropriate
setting for carpet being cleaned - Pg. 7.
1. Remove brush - Pg. 10. Clean brush or debris.
2. Remove brush. Determine if End Caps rotate
freely. If not, replace brushroll - Pg. 10.
3. Set Carpet Height adjustment to appropriate
setting for carpet being cleaned - Pg. 7.
4. Replace belt - Pg. 10.
® Dealer or visit
12
Dealer
®