KRESS 108 AS 1,3 Manual Original página 22

22 English
Specified conditions of use
The machine is intended for driving in and loosen-
EN
ing screws as well as for drilling wood, metal, ce-
ramics and plastic.
Requirements for the user
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
Technical data
Rated voltage of battery in V DC
Capacity in Ah
1. n
0
2. n
0
1. n
1
2. n
1
in rpm
Nm
max. torque hard joint
Nm
max. torque soft joint
Noise levels
L
pA
L
wA
K = Measurement uncertainty value
The noise level can exceed 85 dB(A)
during operation.
Wear hearing protection!
Triaxial
determined in accordance with EN
60745.
K = Measurement uncertainty value
Triaxial vibration emission value in m/
s²: Screws
Triaxial vibration emission value in m/
s²: Drilling metal
AkkuBS_CN-EN / 1004
= No-load speed (1st gear)
= No-load speed (2nd gear)
= Rated speed (1st gear)
= Rated speed (2nd gear)
= A-rated sound pressure lev-
el
= A-rated sound power level
vibration emission
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and accessories, keep the hands
warm, organisation of work patterns.
Corner dimension in mm
Chuck opening range ø in mm
Drilling in steel - max. ø in mm
Drilling in aluminium - max. ø in mm
Fitting screws in wood - max. ø in
level
mm
Drilling in wood - max. ø in mm
Drilling in wood with auger - max. ø in
mm
Weight in kg
Device description