Tools And Accessories - KRESS 108 AS 1,3 Manual Original

28 English
Fixing screws
Before screwing larger, long screws into hard ma-
terials, it is advisable to predrill a pilot hole with the
EN
core diameter of the thread to approx. 2/3 of the
screw length.
Thread cutting
We recommend the use of machine thread taps.
 Lightly oil the thread tap.
 Select low speed and 1st gear.
 Cut in clockwise direction, stop, remove in
anticlockwise direction.
-NOTE-
Always work at low speed when thread cutting.
This prevents the thread tap breaking off.

5. Tools and accessories

When drilling metal, use only sharpened HSS drill
tips (HSS=High-Speed Steel) which are in perfect
condition.
Changing the tool holding fixture
Remove the battery from the device
before undertaking any work on the
device.
This safety measure prevents acci-
dental starting of the power tool.
Observe the notes in the illustrated instructions.
Devices with QuiXS holder (Option)
QuiXS quick change system
Fitting the QuiXS chuck (Accessories)
 Pull the unlocking ring VII back.
 Fit the QuiXS chuck I onto the drill spindle up
to the stop 1 and release the unlocking ring
VII.
-NOTE-
The bit IX in the hexagon-shaped socket 2 can
remain in the drill spindle 1 while fitting the chuck.
Removing the QuiXS chuck
 Pull the unlocking ring VII back and remove
the QuiXS chuck I.
AkkuBS_CN-EN / 1004
Fitting the QuiXS angle adapter (Acces-
sories)
 Remove the bit IX from the hexagon-shaped
socket 2.
 Fit the angle adapter XI onto the drill spindle
1 and twist it until it engages in the desired
position.
-NOTE-
The angle adapter can be engaged in various
angle positions.
 Lock the angle adapter XI in position by tight-
ening the unlocking ring VII.
Removing the QuiXS angle adapter
 Loosen the unlocking ring VII as far as the
stop.
 Take off the angle adapter XI.
Devices without QuiXS holder
On devices not equipped with a QuiXS holder,
have the chuck replaced by an authorised cus-
tomer service station.
Battery lamp
(Special accessories)
The battery operated lamp generates a beam of
light.
Inserting the battery
Use only original KRESS batteries with the volt-
age shown on the rating plate of your lamp.
Use of any other batteries may lead to the risk of
injury or fire.
 Insert the charged battery 5 into the handle
until you feel it click into place.
On/Off
 To start up the battery lamp, press the On/Off
switch XII.
 To switch the battery lamp off, press the On/
Off switch XII again.
Special accessories
Do not use accessories made by other manufac-
turers, as these are not tested by KRESS.
It can be dangerous to use such accessories.
To avoid injury and damage, use only accessories
recommended by KRESS.
Tools and accessories