Utility Panel; Power Supplies - Dell Networking S6000 Guía De Introducción

NOTE: The system light emitting diodes (LEDs) are on the I/O panel. The fan tray
power indicators are on the Utility panel.

Utility Panel

The Utility panel side contains the fan and power modules.
S6000 power supplies and fan modules.
Figure 3-2. S6000 Power Supplies and Fan Modules
1 - PSU 0
2 - Fan Modules 0-2
3 - PSU 1

Power Supplies

The S6000 supports two hot-swappable PSUs. The S6000 supports AC and
DC power supplies with two air-flow directions (I/O to PSU and PSU to I/O).
Two PSUs are required for full redundancy, but the system can operate with a
single PSU.
NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell
Networking recommends using power supply 1 (PSU1) as the blank plate slot.
The PSUs are field replaceable. When running with full redundancy (two power
supplies installed and running), you can remove and replace one PSU while the
other PSU is running without disrupting traffic.
Figure 3-2
Hardware Overview
shows the
11