Accessing The System Remotely; Configuring The Management Port Ip Address - Dell Networking S6000 Guía De Introducción

Accessing the System Remotely

You can configure the S6000 system to be accessed remotely by Telnet. The
system has a dedicated management port and a management routing table that is
separate from the IP routing table.
To access the system remotely, follow these steps.
Step Task
Configure an IP address for the management port
1
Port IP Address).
Configure a management route with a default gateway
2
Management
Configure a username and password
3

Configuring the Management Port IP Address

In order to access the system remotely, assign IP addresses to the management
ports.
To assign IP addresses to the management ports, follow these steps.
Step Task
Enter INTERFACE
1
mode for the
Management port.
Assign an IP address
2
to the interface.
Enable the interface.
3
32
Installing the Software
Route).
Command Syntax
interface ManagementEthernet
slot/port
ip address ip-address/mask
no shutdown
(Configuring the Management
(Configuring the
(Configuring the Username and Password).
Command Mode
CONFIGURATION
INTERFACE
INTERFACE