Publicidad
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
June by netatmo complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NO UNAUTHORIZED MODIFICATIONS - 47 CFR Section 15.21 - CAUTION:
This equipment may not be modified, altered, or changed in any way
without signed written permission from Netatmo. Unauthorized modifi-
cation may void the equipment authorization from the FCC and will void
the Netatmo warranty.
This device complies with FCC RF radiation exposure limits set forth for
general population (uncontrolled exposure). This device must not be col-
located or operating in conjunction with any other antenna or transmitter.
WARNING TO USERS IN THE CANADA
ATTENTION POUR LES UTILISATEURS AU CANADA
June by netatmo complies with Industry Canada licence-exempt RSS stan-
dard(s). Operation is subject to the following two conditions: (1) this device
22
may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada RF radiation exposure limits set
forth for general population (uncontrolled exposure). This device must not be
collocated or operating in conjunction with any other antenna or transmitter.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes: (1) il ne doit pas produire de brouillage, et (2) l'utilisa-
teur du dispositif doit être prêt a accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de compromettre le fonctionne-
ment du dispositif. Conformément à la réglementation d'Industrie Canada, le
présent émetteur radio peut fonctionner avec une antenne d'un type et d'un
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l' intention
d'autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que
la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensi-
té nécessaire à l'établissement d'une communication satisfaisante.
Le présent appareil est conforme aux niveaux limites d'exigences d'expo-
sition RF aux personnes définies par Industrie Canada. Cet appareil ne doit
pas être installé à proximité ou être utilisé en conjonction avec une autre
antenne ou un autre émetteur.
23
Publicidad
