Language Selection; Delay Start - C.P.A. EL 10cl Manual De Regulatión

STAND BY (STOP)
Push and hold the ESC/SBY button for 2 seconds during the functioning to put the pump in stand by
mode:
1) It stops dosing
2) Green on led blinks.
3) If the functioning is PROPORTIONAL the display shows: "Stop 0%" on the first row and the current
measure on the second row (see figure on the left side)
3) If the functioning is Manual or ON-OFF the display shows: "Stop" and the % programmed
frequency on the first row and the current measure on the second row (see figure on the left side)
Push again the ESC/SBY button for 2 seconds to return the pump to the programmed functioning
MENU TREE

LANGUAGE SELECTION

Push and quickly release CAL button and then pressing + and – buttons select the language
choice. Push CAL to enter the language submenu and select "Language English" by pressing +
or - .
Push CAL to confirm the choice and ESC to go back in measuring

DELAY START

Rev 3.0
WHAT IS IT? The delay start is the time in minutes (0-999min) after the
power on that the pump waits before dosing the chemical product. During
this period of time the display shows the message "Delay" on the first row
and the measure on the second row (see figure on the left side). During the
delay start the pump can't dose but it is possible to enter the menu and
modify the parameters and calibrations.
DELAY START EDITING
Push and quickly release CAL button and scroll the menu using + and –
buttons till the display shows "Delay Start". Push CAL to enter the submenu
and then by pressing + and – button choice the value in seconds (0-999).
Push CAL to confirm and ESC to go back in measuring.
Cod. 00.008.255
Push and quickly release CAL
button during the functioning to
enter into the programming menu.
Push + or - button to navigate
through the menu.
Push the CAL button to enter the
submenus
9