Iso Ddin Radio Provision; Important - Metra 99-7428 Instrucciones De Instalación

ISO DDIN radio provision

1. Cut and remove the center bar from the radio
housing. (Figure A)
2. Snap the ISO DDIN brackets to the inside edge of the
radio housing. (Figure B)
3. Slide the radio into the bracket/radio housing
assembly and secure with the screws supplied with
the radio. (Figure C)
4. Snap the ISO DDIN trim plate onto the front of the
radio housing. (Figure C)
5. Locate the factory wiring harness and antenna connector
in the dash and complete all necessary connections to
the radio and climate controls. Metra recommends using
the proper mating adapter from Metra and/or AXXESS.
Re-connect the negative battery terminal and test the
radio for proper operation.
6. Reassemble the dash in reverse order of disassembly.
METRA. The World's best kits.
Installation instructions for part 99-7428
Kit Assembly
(Figure A)
(Figure B)
(Figure C)
metraonline.com
™

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER