Installation Instructions - Hart SAFETY GRIP RAIL Instrucciones De Instalación

Preparing the SAFETY GRIP RAIL for assembly:
1. Open the carton and remove all parts. Remove the plastic coverings and dispose of safely away from children and infants.
2. The SAFETY GRIP RAIL can be used with either two (2) Cross Bars or three (3) Cross Bars. By choosing either the two (2) or three (3)
Cross Bar option you can adjust the SAFETY GRIP RAIL height relative to the floor and to suit the user's preference. For thick
mattresses we recommend that you use 3 Cross Bars. If you choose to use 2 Cross Bars, discard part D (H Bar).
Assembling the SAFETY GRIP RAIL:
3. Snap-lock part A into part B. Repeat
on other side.
SAFETY GRIP RAIL
6. Lastly, snap-lock part E onto either part D or part B. Make sure that all the Snap-Lock
Spring Buttons are in place.
INSTALLER QUICK TIP:
If using part D and you experience any difficulty
when you snap-lock part E into place onto part D,
loosen the screws 121 on part D using the
.
allen key provided
7. Adjustments may be needed to tighten or loosen part D (H Bar) for proper fit. You are now ready to install the SAFETY GRIP RAIL
onto your bed.
SAFETY GRIP RAIL

Installation Instructions

4. Screw part C onto parts B. Leave
screws loose.
Low Profile
with 2 bars
SAFETY GRIP RAIL
High Profile
with 3 bars
121
C
5. If you are using part D (H Bar),
snap-lock part D onto part B.
E
121
E
D
C
2