Sears Kenmore 146.47223610 Manual De Uso Y Cuidado página 25

Side burner
□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws and washers
holding side burner in place. (A). Note: Do not loosen electrode screw.
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□ Insert valve stem through hole in fascia. (D). Install previously removed 2 screws .Note: Do not tighten
these 2 screws until the bezel is attached to fascia and valve face.(E).
□ Insert bezel openings over valve stem and the 2 screws(F). Slide bezel down onto screws. Make sure
that black mark on bezel is vertical. Tighten the 2 screws to secure bezel to fascia(G).
□ Place side burner tube over the valve, making sure that valve is inside side burner tube. (H)
□ Push control knob onto side burner valve stem. (I)
□ Reattach side burner to side burner shelf with the 2 previously removed screws. Replace side burner
grate. (J)
□ Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.(K)
□ Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (L)
A
A
C
E
B
D
F
H
146.47223610 • 25