Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare your mobile stand or ground anchor as instructed by their corresponding manual and have the required
accessory hardware ready for install. All sheet stands that use pavers should have the appropriate pavers installed
and fillable stands should be filled with appropriate weighted material.
For safety-purposes, two people should set up the umbrella.
Before setting up the umbrella, make sure the area is clear of people and objects underneath that could be harmed
or damaged and or could cause damage to the umbrella.
Please be aware, that the umbrella is very tall, and thus hard to balance in an upright position. For this reason hold
the umbrella firmly when installing to reduce the risk of injury.
Bring the bottom of the umbrella to the stand. One person guides the mast into the tube of the stand while the
other person pushes the umbrella into an upright position. The pole should slide into the tube of the stand. Secure
with tightening knobs. Alternatively, one person can press the mast to the ground (creating a stopper for the mast
with their foot) while the second person pushes the umbrella into an upright position next to the stand. Then the
umbrella is lifted into the tube of the stand.
The purpose of the plastic mesh attached to the struts is to provide protection to the shade against
damage during transport. Once the umbrella is open, the mesh can be removed carefully with scissors or
a knife. Be careful not to damage the shade!
RIVIERA 2012 Page / Seite / Page / Página 3
SETTING UP THE UMBRELLA
Remove the protection bag before installing if
you do not have a push-rod which enables you to
remove the protection bag from a set up umbrella.
Publicidad
