Tabla De Contenido - Pioneer DVH-P5000UB Manual De Instrucciones

Contents
Connecting the Units ................................ 1
Power cable connection .................................... 3
Connecting to separately sold power amp ........ 5
When connecting with a multi-channel
processor .................................................... 7
Connecting and installing the optical cable
connection box .......................................... 8
When using a display connected video
outputs ........................................................ 9
When connecting with a rear view camera .... 10
Installation ................................................ 11
DIN Front/Rear-mount .................................... 12
DIN Front-mount ............................................ 12
DIN Rear-mount .............................................. 13
Fastening the front panel ................................ 13
1
Connecting the Units
Note:
• When this unit is installed in a vehicle without
ACC (accessory) position on the ignition switch,
red cable must be wired to the terminal that can
detect the operation of the ignition key.
Otherwise, battery drain may result.
ACC position
• Use this unit in other than the following condi-
tions could result in fire or malfunction.
- Vehicles with a 12-volt battery and negative
grounding.
- Speakers with 50 W (output value) and 4 ohm
to 8 ohm (impedance value).
• To prevent short-circuit, overheating or malfunc-
tion, be sure to follow the directions below.
- Disconnect the negative terminal of the bat-
tery before installation.
- Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap adhe-
sive tape around them where they lie against
metal parts.
- Place all cables away from moving parts,
such as gear shift and seat rails.
- Place all cables away from hot places, such as
near the heater outlet.
- Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
- Cover any disconnected cable connectors
with insulating tape.
- Do not remove RCA caps if RCA cables are
not used.
- Do not shorten any cables.
- Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
- Use a fuse of the rating prescribed.
- Never wire the speaker negative cable direct-
ly to ground.
- Never band together multiple speaker's nega-
tive cables.
No ACC position