Drain Hose Kit: Fitting Instructions - Candy GVH 9913NA2 Manual De Instrucciones

DRAIN HOSE KIT: FITTING INSTRUCTIONS

Do not install the product in a low temperature room or
in a room where there is a risk of frost occurring. At
temperature around freezing point the product may not be
able to operate properly: there is a risk of damage if the
water is allowed to freeze in the hydraulic circuit (valves,
hoses, pumps). For a better product performance the
ambient room temperature must be between +2°C and
+35°C. Please note that operating in cold condition
(between +2 and +15°C) might imply some water
condensation and water drops on floor.
DRAIN HOSE : FITTING INSTRUCTIONS
To avoid emptying the water container after
each drying cycle, the water can be
discharged directly to a waste water drain pipe
(the same drainage system as household
sinks). Water Bye-Laws prohibit connection to
a surface water drain. The waste water drain
pipe should be located adjacent to the tumble
dryer.
The kit consists of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit the Hose as Follows:
1.Flip the machine
slowly to the right side.
2. The waste water
pipe is situated at the
right-hand side of the
machine (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the pipe
retaining clip from the
bridge.
3. Pull the hose off the
bridge connection.
EN 8
4. Attach the black
hose from the kit,
(using the connector
a n d p i p e c l i p s
supplied), to the hose
removed from the
bridge connection.
5. Once the machine is
in place, check the
bottom to ensure that
the new hose does not
kink when pushing the
t u m b l e d r y e r i n t o
position.
6. Connect the new
drain hose to the waste
Water pipe.
7. Connect to the
m a i n s e l e c t r i c i t y
supply.
Caution: If the product
is in different side, wait
at least 4 hours before
switching on so that the
oil can flow back into
t h e c o m p r e s s o r .
Failure to do this could
result in damage to the
compressor.