Hot Lamination; Cold Lamination; Clearing Foil Jams; Cleaning And Servicing - Olympia A 233 Guia De Inicio Rapido

Hot lamination

1. Connect the power plug to a properly installed power
socket.
2. Set the Cold/Off/Hot switch on the right-hand side of
the device, to "Hot". The red Power LED lights up.
Æ The drive motor for the transport rollers starts up. The
correct operating temperature is reached after about
6-10 minutes and the green Ready LED lights up.
3. Insert the document to be laminated in the foil pocket
so that there is a margin of approx. 3 - 5 mm to the
edge of the foil on all sides.
4. Insert the foil pocket containing the document in the
infeed slot at the front of the laminator. Feed in the
closed side of the foil pocket first. The laminating pro­
cess occurs automatically.
5. When the lamination process has been completed,
set the Cold/Off/Hot switch on the right-hand side of the
device, to "Off". Disconnect the power plug from the
power socket, if necessary.

Cold lamination

1. Connect the power plug to a properly installed power
socket.
2. Set the Cold/Off/Hot switch on the right-hand side of
the device, to "Cold". The red Power LED lights up.
Æ The drive motor for the transport rollers starts up and
the green Ready LED lights up.
If you have just finished using the laminator for hot
laminating, you must let the laminator cool down.
The cool down phase takes about 15 minutes.
3. Insert the document to be laminated in the foil pocket
so that there is a margin of approx. 3 - 5 mm to the
edge of the foil on all sides.
4. Insert the foil pocket containing the document in the
infeed slot at the front of the laminator. Feed in the
closed side of the foil pocket first. The laminating pro­
cess occurs automatically.
5. When the lamination process has been completed,
set the Cold/Off/Hot switch on the right-hand side of the
device, to "Off". Disconnect the power plug from the
power socket, if necessary.
6

Clearing foil jams

The laminator is provided with the "ABS Jam Release"
function in order to clear foil jams quickly.
- In the event of a foil pocket jam, switch the laminator off
and press the "ABS" button on the left-hand side of the
device.
- Hold the laminator firmly and pull the foil pocket, to­
gether with the document to be laminated, out of the lam­
inator's infeed slot.
- It may then be necessary to clean the unit several times
as described in the Section "Cleaning and Servicing".

Cleaning and servicing

Deposits and residual adhesive on the transport rollers
can influence the results of the laminating process. There­
fore, the transport rollers must be cleaned periodically
after use:
To do this, insert a folded piece of paper in the infeed slot.
Residual adhesive is removed and taken up by the paper
when ejected. Repeat the process several times.
Always disconnect the power plug before starting to clean
the housing. If necessary, the housing can be cleaned us­
ing a cloth moistened with clean water with a little mild
soap applied. Never use any solvents or aggressive
cleaning agents.
Troubleshooting
• Foil jam
Æ To clear the fault, follow the instructions in the Section
"Clearing foil jams".
Æ Only use foil pockets of the size specified.
Æ Ensure that the foil pocket has been inserted correctly
in the unit.
Æ Check the foil pockets being used are the correct size.
• Laminated foil pocket is not completely transparent
Æ Laminate the same foil pocket again to improve the
lamination result.
Æ If you want to laminate thicker foil pockets (100 μm,
125 μm), please allow a longer warm-up phase.
G