Menu Functions; Auto Mode - HQ-Power VDPLOW1803RGB Manual Del Usuario

c) general
• Make sure there is no flammable material within a 50cm radius of the device and there is sufficient
cooling.
• Have a qualified electrician carry out the electrical connection.
• All fixtures must be powered directly off a grounded switched circuit and cannot be run off a
rheostat or dimmer circuit, even if the rheostat or dimmer channel is used solely for 0% to 100%
switch.
• The installation has to be approved by an expert before the device is taken into service.
• The VDPLOW1803 has a power output to supply power to another VDPLOW1803RGB. Do not
daisy-chain more than 7 VDPLOW1803RGB's on this output!
• When the temperature of the fixture becomes too high, the LEDs will dim due to the internal
overheating protection system. Unplug the fixture and let it cool down to restore the LEDs
brightness.
7. Operation
Refer to the illustrations on page 2 of this manual.
• There are 4 working modes: Auto, Sound controlled, DMX controlled and Slave.

Menu functions

• Use the navigation buttons [A, B, D & E] to scroll through the menus.
• Press the MENU button once to display the firmware version.
• Press the MENU button 2 times to enter the working mode selection menu. Use the
to display the desired mode and press the
• Press the MENU button 3 times to enter the slave mode setup menu. Use the
select the number of slaves, the software or waiting time. Press the
and buttons to change settings; press the

Auto mode

• Use the and
• For program 01~10, press the
speed with the
and buttons. Press the
buttons. Press the
• For program 11~17, press the
speed with the
• In program 18, all other programs are shown sequentially. Press the
time setting (this is the time each program runs) and set the desired value with the
(001~240).
14.06.2011
VDPLOW1803RGB
buttons to scroll through the available programs (01~18).
button to enter output speed setting (001~240); set the desired
and buttons. Press the
button to confirm and set the effect (01~12) with the
button to confirm.
button to enter output speed setting (001~240); set the desired
and buttons. Press the
button to select.
button to confirm.
button to confirm and set the colour (01~13) with the
button to confirm.
5
and
and buttons to
button to select; use the
and
button to enter the output
and
©Velleman nv
buttons
buttons