Initial Setup - Primo Water 900178 Manual Del Usuario

Initial Set Up
Do NOT plug in until steps 1-3 are completed.
1.
Allow unit to sit upright for 4 hours.
2.
Set probe length (see illustration 1):
•
If using a 5 gallon round bottle, use the probe as it is supplied.
•
If using a 5 gallon rectangular bottle, remove section C. Save for
future use.
•
If using a 3 gallon bottle, remove sections C & B. Save for future
use.
3.
Install bottle:
•
Open door and place fresh bottle in front of tray.
•
Clean fresh bottle with a soft cloth and warm soapy water then rinse.
•
Remove entire plastic cap from top of bottle.
•
Insert probe into bottle.
•
Push down on probe until it is seated.
•
Create a seal by turning handle clockwise until tight – do NOT over tighten.
•
Slide bottle onto tray and close door completely.
NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in
illustration 2.
Model # 900178: Page 6