Correct Use; Safety Instructions - Kerbl EasyHeat 23A Instrucciones De Uso

Instructions for Use - EasyHeat 23A / 30A
EN
1. General
These operating instructions comprise instructions for use and safety information. Please read the instructions
carefully and note the regulations and relevant information before putting the device into operation.
Please keep these operating instructions in a safe place for later use!

2. Correct use

The calf milk heater EasyHeat 23A / 30A is intended for warming milk and feed prepared using water. The calf milk
heater must not be used for other purposes, in particular to prevent the freezing of water in feeding troughs and to
warm up corrosive liquids. In the event of incorrect use or modifications to the device, the manufacturer's warranty
and liabilities shall be deemed invalid.
The function of the calf milk warmer EasyHeat 23A / 30A has been optimised for use in cylindrical containers with an
average diameter of max. 22 cm and for volumes of liquid of up to 10 litres. In the event of any deviating
conditions, a longer heat-up time may be required and there may be temperature deviations. The EasyHeat 23A /
30A device cannot be used as a temperature measurement device.

3. Safety instructions

CAUTION!
Hot surfaces and defective connection cables. Risk of burns, electrical shock, fires and short circuits.
• Do not place device on objects or surfaces that are sensitive to heat.
• The surface of the heater will still be hot when the device is switched off!
Do not touch the heater or place it on heat-sensitive surfaces.
• Ensure that the container for the liquid to be heated is made from a heat-resistant material.
Do not use any synthetic material containers.
• Only operate the device in the liquids it is intended for.
• Do not allow electrical supply cables to come into contact with hot surfaces,
heat, oil or sharp edges.
• Do not pull on the electrical supply cable to unplug or transport the device.
Hang up electrical supply cable on the integrated cable holder (5) when the
device is not in use.
• Do not exceed the maximum immersion depth! ("max" position, see page 13)
• Never go above the minimum immersion depth! ("min" position, see page 13)
Risk of physical injury and material damage if used incorrectly!
• Ensure that the device is only used by people who have the professional
skills required to do so.
• Ensure that the voltage specified on the type plate matches the voltage
of your power source.
• The device may only be connected to mains sockets which are isolated separately
via a 30 mA circuit breaker (FI).
• Do not use any multiple sockets. This is a very powerful high performance
device.
• Before each use, check that the device and the power cable in particular are in
good condition. Do not operate the device if a component is defective.
• Repairs may only be performed by a qualified electrician or the manufacturer.
12
max
min