SCHOLTES B 40 L EC Serie Manual De Instrucciones página 18

GB
Securing the appliance to the cabinet Securing the appliance to the cabinet Securing the appliance to the cabinet Securing the appliance to the cabinet Securing the appliance to the cabinet
There are three different groups of appliance as far
as installation is concerned:
1 1 1 1 1 - Built-in hobs to be slotted in (Class 3 - see
figure 2, detail H1). In this case it is necessary to
make a hole in the worktop whose
measurements match those of the hob. The
measurement at the side should be reduced by
10 mm for horizontal sides and 6 mm for vertical
sides, in order to ensure that 10 mm of the hob
perimeter overlaps with and rests on top of the
supporting surface for horizontal sides (this
figure should be 6 mm for vertical sides, see
figure 4a-4b). To slot in the hob flush with the
worktop, the cut-out on this supporting surface
must be lowered, so that both the edge of the
hob and the seal under it can be positioned
there.
18
Fig. 1
Fig. 3
Before fitting the hob to the worktop, position the
seal provided along the perimeter of the hob, as
illustrated in Fig. 5. Brackets for fixing worktops to
the cabinet have been provided, and these should
be fitted as shown in detail S S S S S (Fig. 3). . . . .
2 2 2 2 2 - Built-in hobs (Class 3) with edges lower than 88
mm (see figure 2, detail H2);
to install this type of hob, a hole large enough to
accommodate the whole lower casing of the
appliance must be made on the worktop
intended to be under the hob. Remember to
leave a gap of at least 1 cm between the lower
casing and the worktop around the whole
perimeter of the appliance (the underside of the
casing can, however, touch the surface below it).
To fit the appliances, follow the instructions
given above in point 1 or use any supplementary
instruction leaflet that is provided in special
cases.
3 3 3 3 3 - Sit-on hobs (Class 1) with edges higher than 88
mm (see figure 2, detail H3). In this case, the
lower casing of the hob does not protrude
further than the edge of the appliance. Even
when the hob is resting on the worktop, it will
Fig. 2
suffice to leave space for the gas supply tube
and electricity supply cable.
N.B.: If the appliance is installed above an oven, a N.B.: If the appliance is installed above an oven, a N.B.: If the appliance is installed above an oven, a
N.B.: If the appliance is installed above an oven, a N.B.: If the appliance is installed above an oven, a
wooden panel must be fitted underneath the hob as wooden panel must be fitted underneath the hob as
wooden panel must be fitted underneath the hob as wooden panel must be fitted underneath the hob as wooden panel must be fitted underneath the hob as
insulation. It should be fixed at least 20 mm away insulation. It should be fixed at least 20 mm away
insulation. It should be fixed at least 20 mm away insulation. It should be fixed at least 20 mm away insulation. It should be fixed at least 20 mm away
from the hob casing. from the hob casing. from the hob casing. from the hob casing. from the hob casing.
The appliance must be fitted to the kitchen cabinets
using suitable fixing accessories (these are provided)
which may vary according to the type of installation
required and the proportions of the appliance.
6 mm