Care And Maintenance - Hyundai LM3601E Manual Original

that the cable always lies on the already
mowed lawn surface. Be careful when
turning the device.
• Your device is equipped with an overload
protection. It can trigger when the device
is overloaded, e.g. when mowing high
and too wet grass, during engine
blockage and / or overheating. When the
overload protection is triggered, the
engine is switched off automatically. If
this happens:
- Unplug the power plug from the
socket,
- Allow the device to cool down for 5 to
10 minutes,
- Inspect the device for damage and
blockages,
- Check whether the blade is still sharp
enough. When working on the blade,
care must be taken to protect the
hands. Please wear the appropriate
gloves.
After cooling and eliminating possible
errors, try to restart the device. If it does
not start or shut down again, contact an
authorized service center.

CARE AND MAINTENANCE

For a long, safe and reliable use, regular
care and maintenance
recommended. We recommend cleaning
the lawn mower after every use.
Caution: Care and maintenance may
only be carried out when the lawn
mower is turned off and cooled down.
Disconnect the power plug of the
device. before working on the lawn
mower in any case. When working on
the blade, the hands need to be
protected. Wear appropriate gloves.
Cleaning and Inspection
F1: Disconnect the power plug of the
device. Remove remaining grass clippings,
dust and dirt with a brush from the lawn
mower surface. Alternatively, you can use
pressurized air. While doing that, wear
hearing protection and eye protection.
Make sure that no other persons are
around.
F2: Do not use water. It may damage the
electrical component of your device. Never
clean your lawn mower with a pressure
washer. Do not use any chemicals, petrol
or solvents to clean it, especially not on
plastic parts. This could lead to damage of
these parts and the protective coating.
Clean the lawn mower with a wet cloth.
• Regularly check if all screws, nuts and
bolts are tightened correctly.
• Check if all protective devices and covers
are
functioning. Damaged or worn parts
need to be replaced with original parts.
• Regularly check the grass catcher. If the
grass catcher is damaged, sucked in
objects could be ejected at speed. This
could possibly lead to injuries or damage.
• To clean the grass catcher, detach it from
the lawn mower, wash it with water and
let it dry.
catcher is completely dry before using it
again.
is highly
Blade Maintenance (Image G)
Before the blade maintenance, the device
should be disconnected from the mains and
cleaned. Remove the grass basket. Wear
the appropriate gloves. A wooden block is
needed to pinch the blade (not included).
G1: Place the device on the side. Clamp
the wooden block so that the blade can not
rotate. Use the wrench (not included) to
loosen the screw. Remove the screw, shim
and blade.
attached correctly
Make sure that the grass
EN 15
and are