Proline GR800 Manual De Instrucciones página 12

Setting the fan speed (remote control only)
Repeatedly press
The corresponding speed indicator will be shown on the remote display to indicate which speed setting is in
use.
In AUTO, cool ( ) and fan only (
middle speed and
NOTE:
• When
is shown on the remote display in cool mode, the fan speed is same with
• If the appliance is in dehumidification (
Setting the timer (remote control only)
Programming the timer for ON – when the appliance is OFF.
Press . The timer on indicator will flash.
Repeatedly press or hold down
then in 1 hour increments up to 24 hours.
Press to confirm and the timer on indicator will stop flashing. The timer starts.
When the set time has been reached, the appliance will turn on automatically.
Programming the timer for OFF – when the appliance is operating.
Press The timer off indicator will illuminate.
.
Repeatedly press or hold down
Press to confirm and the timer off indicator will stop flashing.The timer starts.
When the set time has been reached, the appliance will turn off automatically.
To cancel the timer setting
Press until the time on/off indicator disappears on the remote display.
to select the fan speed.
) modes, you can select from AUTO speed,
high speed.
) mode, you can not select the fan speed.
−
+
/ to change the time in half an hour increments up to 10 hours, and
−
+
/ to change the time in half an hour increments up to 24 hours.
10
low speed,
high speed.