König KN-RFROKIT Manual De Instrucciones página 2

The radio control units included in the packaging are already
programmed in bistable mode and ready to use. To reprogram the
remote controls, please follow below steps.
Programming the König receiver or additional remotes:
(To be performed on the receiver, picture 1)
The receiver can be programmed into: monstable or bistable
mode
This König remote can be programmed to control output 1 and output 2
of the receiver in bistable or monostable mode.
Example1: With the monostable mode, you can sent out a pulse to the
central unit of an automatic gate and open it.
Example 2: With the bistable mode, you can switch on a device (like a
lamp) by pressing the button one time, to switch off the device you have
to press the same button once again.
Example 3: If you use the monostable mode with a lamp, you push the
button to switch on the lamp, but when you release this button the
lamp switches off.
So, you only should use the monostable mode if you need a pulse,
otherwise you have to use the bistable mode.
STEP 1:
Press the P1 button on the receiver:
1 time to program output 1 in monostable mode.
2 times to program output 2 in monostable mode.
3 times to program output 1 in bistable mode.
4 times to program output 2 in bistable mode.
STEP 2 (perform immediately after step 1 is carried out):
Keep pressing button A or B on the König remote (picture 2) that you
want to sync until the LED on the receiver begins to flash.
Erasing codes
There are two types of erasing.
A: Erasing of an individual code:
Press key P2 for approx. 2 seconds (release the key); the LED will light
up, press the key on the König remote control you would like to delete.
B: Erasing all acquired codes:
Press key P2 until the LED lights up (approx. 8 seconds).
ENGLISH
Ant Aux
Not included
Receiver