ELICA HIDDEN HT IXGL/A/60 Montaje Y Modo De Empleo página 21

Manual setting
To be performed when you notice that automatic operation is
functioning unsatisfactorily; it must be performed when there
are normal environmental conditions in the kitchen.
Manual setting includes:
• Calibration of the hood:
• Selecting the type of hob (gas - induction or electric).
• Connection with SNAP® (when installed).
Calibration of the hood:
Hold down the button T1 (approximately 10 seconds), the LED
L1 flashes to indicate that calibration has begun, the
calibration process will last about 5 minutes.
Selecting the type of hob (gas - induction or electric)
Hold down the button T2 (about 10 sec), all the LEDs start
flashing for 5 sec.
Within this period press T1 to select the hob that you own:
Orange LED: gas hob.
Blue LED: induction hob.
White LED: electric hob
Wait 5 sec. to allow the hood to record the selection made and
until all LEDs go out.
Connection with SNAP® (when installed).
The connection between the hood and SNAP® is automatic –
no settings are required.
Maintenance
Cleaning
Clean using ONLY the cloth dampened with neutral liquid
detergent. DO NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Panel
Fig. 9-11-12-13
Maintenance of the panel
Disassembly:
a. pull the panel (FRONT SIDE) downwards energetically
b. unhook it from the back hinges.
Cleaning:
the suction panel must be cleaned as frequently as the grease
filter, use a dampened cloth with neutral liquid detergents.
Avoid using products containing abrasives. DO NOT USE
ALCOHOL!
Assembly:
The panel must be hooked in the back and fixed in the front
(with magnets).
Attention! always check that the panel is tightly fixed to its
place.
Grease filter
Fig. 9-12
Traps cooking grease particles.
The grease filter must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
CLEAN WITH TOOLS
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
Fig. 10
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
Circular carbon filter
Apply one on each side as cover to both the shield grids of the
motor impeller, then turn clockwise.
For the disassembly, turn counter-clockwise.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
OR
21