Increasing/Decreasing The FLushing Duration Of The Pre-FLush (Activating/Deactivating) (On The Mains Version) - DURAVIT DuraSystem WD5006 Manual De Uso

...
Increasing/decreasing the flushing duration of the pre-flush (activating/deactivating)
(on the mains version)
A pre-flush can also be activated for the main flush on the mains version of the actua-
tor plate that is triggered automatically when a person enters the detection range.
You can increase or decrease the duration of the pre-flush by pressing the "Pre-flush"
button on the remote control (see table 3: Setting the pre-flush).
> Press the "+" setting button if you want to increase the flushing duration.
> Press the "-" setting button if you want to decrease the flushing duration.
The status LED flashes twice each time you press the button. The flushing duration is
increased/decreased by the corresponding steps.
The flushing duration is set to 0 seconds in the factory, i.e. the pre-flush is deacti-
vated. The pre-flush is activated as soon as the flushing duration of the pre-flush is
increased by one step.
The status LED flashes 5 times in succession if you have reached the maximum or
minimum range.
Flushing duration
Table 3: Setting the pre-flush
Activating/deactivating the hygiene flush
If the urinal is not used for a longer period of time, the automatic hygiene flush trig-
gers flushes at regular intervals to avoid stagnant water in the pipe system.
You can activate the hygiene flush and also deactivate it again via your remote control
(see table 4: Setting the hygiene flush).
> Press the "Hygiene flush" preselection button on your remote control.
The status LED flashes 5 times on the control panel. The hygiene flush is activated.
The status LED flashes once on the control panel. The hygiene flush is deactivated.
44
Factory settings
0 sec.
Setting range
Approx. 0, 1, 2, 3, 4 sec.