Triggering Manual FLushing (Mains Version Only); Reset; Activating/Deactivating The Dynamic FLush Volume - DURAVIT DuraSystem WD5006 Manual De Uso

Triggering manual flushing (mains version only)

Reset

You can reset all settings to the factory settings and restart the software with the reset
function. You can perform a reset via the "Reset" button on your remote control (see
1.2 Remote control).
> Press the "Reset" preselection button on your remote control for 3 seconds.
The status LED flashes 3 times on the control panel. The settings are reset to the fac-
tory settings.
Activating/deactivating the dynamic flush volume
The "Dynamic flush volume" automatically reduces the duration of the flushes in the
case of high usage levels, thus reducing water consumption. This reduction is tem-
porary and the system automatically returns to normal mode when the usage levels
decrease again.
You can activate the dynamic flush volume and also deactivate it again via your remote
control (see table 5: Dynamic flush volume).
> Press the "Dynamic flush volume" preselection button on your remote control.
The flushing can be triggered manually
when the presence detection is deactivat-
ed.
> Hold your hand 5-6 cm in front of the
button for approx. 2 seconds.
The flush is triggered.
47