Filling With Water; Making Espresso; Getting Hot Water - Taurus MERCUCIO Manual De Instrucciones

- To finish serving, as quantity of liquid is pro-
grammed, it will stops automatically, but you
always can stop when desired. To do it, push
again over coffee button to stop and close the
steam knob (R) by turning clockwise
- This will complete the priming operation.

FILLING WITH WATER:

- The tank must be filled with water before turn-
ing the appliance on.
- Remove the water tank.
- Fill the tank taking care to observe the MAX
level
- Replace the tank in its housing, ensuring that it
is well fitted.
FILLING OF COFFEE:
- Remove the filter holder.
- Position the ground chosen coffee filter (L ó M)
in the filter holder
- We recommend using natural toast coffee, as
using roasted coffee may affect the operation
of the machine.
- Fill the removable filter with ground coffee (6 to
7 gr per cup to be prepared).
- If you wish to make 1 coffee, use 1 filter coffee,
fill the ladle (1 spoonful) and take the capacity
of the measuring spoon as the measure for one
coffee.
- For 2 coffees, use 2 cups filter (M), and put in
2 spoonfuls.
- Next lightly press down the ground coffee with
the back of the spoon.
- Fit the filter holder in the appliance once more.
- Position the filter holder in the coffee assem-
bly by inserting the assembly from below to
inserting position and turning it from left to right
until it locks.
USE

MAKING ESPRESSO

- Before connecting the machine, check that
steam control (R) is closed, turning clockwise.
- Connect the appliance to the mains.
- Turn the appliance ON pushing the on/off
button(F).
- The indicators of 1 cup of coffee and 2 cup of
coffee flash, the machine begins preheating.
- After indicators are solidly on. It means right
temperature is reached.
- Place one or two pre-heated cups at the filter
holder outlet.
- Press the coffee Button (G1 or G2). The coffee
infusion will begin to exit.
- The coffee will stop automatically when rea-
ched the standard quantity.
TO CUSTOMIZE THE VOLUME OF COFFEE
- Press and hold 1-cup button for 3 seconds,
1-cup button flashes, entering setting mode,
press 1-cup button again to start dispensing
coffee, when the specified time is reached,
press 1 cup button to complete setting which
can be memorized by the unit. You can do
same for 2 cups button.
- Once serving has finished, wait a few seconds
and remove the cups with the coffee.
- Remove the filter holder and empty the
grounds from it.
- Wash the filter holder with running water and
dry it well.
- Check that the removable filter is perfectly
fitted into the filter holder.
- Fit the filter holder in the appliance once more.

GETTING HOT WATER:

- Put the device in ON situation, pressing the
button ON/OFF (F).
- The indicators of 1 cup of coffee and 2 cup of
coffee flash, the machine begins preheating.
After all indicators are solidly on, the prehea-
ting is completed. This situation indicates that
the water has reached the right.
- Place a container under the nozzle.
- Open the steam control (R), turning him to the
left, counterclockwise.
- Press one of coffee outlet button (G1-G2).
- Please refer to the operation described in the
section of "Making Espresso" when need to
adjust the working time for making hot water.
- The hot water began to come out of the vapo-
rizer.
- Once obtained the desired amount of hot water,
press the coffee outlet button (G1 or G2) again,
which stops the pump.