Wireless Instruction Mode (Slave C /Slave N) - Rollei 56 Manual De Instrucciones

Wireless Instruction Mode (SLAVE c /SLAVE n)

70
SLAVE c: This indicates that only wireless flash signals from the camera flash
of Canon 7D/60D/60c (built-in flash) and 580EX II, 600EX, ST-E2 and the Vice
factory MASTER wireless flash signal can be received .
SLAVE n: This indicates that C instruction sign from Nikon camera built-in flash
instruction and SB-900/800/700, SU-800 and the Vice factory MASTER command
signal can be received .
SLAVE c/n: This supports 4 channels, 3 different groups, TTL, Manual and Multi
Wireless flash . Before shooting, you need to set up the same channel about the
MASTER and SLAVE unit .
Shortly press the Zoom Button until channel or group twinkles for the
SLAVE unit to set the communication channel of the SLAVE unit (1 .2 .3 .4) as well
as the SLAVE unit group (A .B .C) .
When working in a SLAVE unit, the
flash light and mode are completely
con trolled by the MASTER unit and only
display the received information.
Note:
• Flash light and mode in wireless instruction mode can't be set directly . It will
only be set by the MASTER unit .
• To use the wireless command mode correctly, you must set the communication
channel and group correctly .
ENGLISH