Tabla De Contenido; Assembly; Tools Required For Assembly - Agri-Fab 45-0331 Manual Del Usuario

CONTENTS
SAFETY ........................................................................... 4
ASSEMBLY ...................................................................... 5
OPERATION .................................................................. 11
MAINTENANCE ............................................................ 11
STORAGE ..................................................................... 11
SERVICE AND ADJUSTMENTS ................................... 12
TROUBLESHOOTING ................................................... 12
REPAIR PARTS ............................................................. 22

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(1) Knife or Scissors
(2) 1/2" Open End or Box End Wrenches
All loose parts are shown on page 2. Fasteners in the parts
bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown on
pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined
from the operator's position while seated on the tractor.
1. (Figure 1) Assemble the angle bracket to the sweeper
housing using a 5/16" x 3/4" hex bolt (F) and a 5/16"
hex lock nut (G). Make sure the bracket is turned as
shown and aligned straight with the housing and then
tighten.
5/16" HEX
LOCKNUT (G)
ANGLE
BRACKET
5/16" x 3/4"
HEX BOLT (F)
ENGLISH
2. Cut off the plastic tie that holds the height adjustment
tube in place.
3. (Figure 2) Assemble the R.H. hitch tube to the sweeper
housing using two 5/16" x 1-1/2" carriage bolts (D),
5/16" lock washers (K) and 5/16" hex nuts (H). Do not
tighten yet. Repeat for the L.H. hitch tube.
5/16" HEX
LOCK NUT (G)
4. (Figure 3) Fasten the hitch tubes together using two
5/16" x 2-1/2" hex bolts (A), 5/16" small fl at washers
(I), 5/16" lock washers (K) and 5/16" hex lock nuts (G).
Do not tighten yet.
1
5/16" x 2-1/2"
HEX BOLT (A)
5
5/16" x 2"
HEX BOLT (B)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
3/4" SPACER (U)
HITCH BRACKET
1/8" HAIR
COTTER PIN (N)
5/16" HEX
LOCK NUT (G)
5/16" LOCK
WASHER (K)
5/16" SMALL FLAT
WASHER (I)
2
3