Publicidad
Idiomas disponibles
Idiomas disponibles
12
32. Secure the fog lamp harness with cable ties along the existing harness under the front fascia.
NOTE: Cable ties should be spaced no farther than 100mm apart on the outside of the vehicle.
33. Drill a 3/16 inch hole in the plastic tab just inside
the fog lamp mounting and secure harness with
a cable tie as shown.
Repeat for driver side.
34. Remove the original headlamp switch by following
these steps:
1) Turn the knob to the OFF position.
2) Push in on the knob to engage the retractor
mechanism.
3) With the knob pushed in, rotate the knob
clockwise (right) to retract the two retaining tabs.
7/24/12
D
3
2
1
K6861310
Publicidad
