Mopar 82212851 Instrucciones De Montaje página 14

14
BCM Fog Light Configuration
Vehicle VIN must be updated with the sales code of the added accessory in order to enable system functionality. Using
the DealerCONNECT website and the scan tool, complete the procedure below:
1) Log on to https://dealerconnect.chrysler.com
2) In the service tab, inside the Warranty Administration box, locate “Vehicle Option Updates.” Enter the vehicle VIN and
add the sales code LNJ (Fog light) as a “Dealer Installed Option.”
3) Confirm that the new sales code has been successfully added to the VIN.
With the scan tool connected to both the internet (via Ethernet port or wireless connection) and the vehicle, follow the
steps below:
4) Use scan tool to run Restore BCM Proxi Configuration which can be found in the Vehicle Preparations tab of the
main topology screen. Following the prompts will upload the new vehicle PROXI configuration to the BCM.
5) Once that is done, run Proxi Configuration Alignment found in the Vehicle Preparations tab to update the rest of
the ECUs on the vehicle with the PROXI configuration that is now stored in the BCM.
6) Follow the step by step instructions on the scan tool to complete the Fog light vehicleconfiguration.
Fog Light Alignment
The fog lamp adjustment screw is accessed through clearance holes near the right and left outboard ends of the
belly pan below the front fascia. A properly aimed front fog lamp will project a pattern on the alignment screen
100mm (4 inches) below the fog lamp centerline and straight ahead of the lamp.
1) Turn the fog lamps ON.
2) Rotate the fog lamp vertical adjustment screw on each lamp to adjust the beam height as required.
7/24/12 K6861310