How To Change The Blades - JAC FACE+ Traducción Del Manual Original

Make sure that you wear anti-cut protective gloves when replacing the blades or carrying
out operations in the vicinity of the blades.
Once you have ensured that your machine is actually disconnected from the mains :
1. Remove the stainless steel table at the front of the machine ;
2. Remove the bagging spade, open the shroud that protects the frames supporting the
blades ;
3. At the top of the front frame, loosen the screws fastening the frame to the polypropyl-
ene lamellas (never unfasten the lamellas from the framework, as you might alter the
default settings) ;
4. Tilt the frame forwards ;
5. Replace the blades of the front frame :
- Loosen the hexagonal socket head screws which tighten the blades ;
- Replace the blades and check that they are well positioned in the rocker arm
pin ;
- Re-tension the blades by tightening screw, so that the blades remain in the
frame as a mark of tension ;
- Then tighten the nuts (machine fitted with the lubrication option).
In order not to warp the frame and avoid dangerous breaks, only replace 4 or 5
6. Resume the sequence from point 3 to 6 for the rear frame (place some kind of protec-
tion on the front frame blades) ;
7. Re-assemble the frames while ensuring that you do not over-tighten the frame lamel-
las.
Connect your machine to the mains, it is now ready.

HOW TO CHANGE THE BLADES

blades at a time.
11