Assembly And Adjustment - DeWalt D215851 Manual De Instrucciones

E N G L I S H
18 D215825 Fastening set for concrete
19 D215826 Fastening set for masonry
20 D215827 Spare dowel for concrete (10 pcs)
21 D215828 Spare dowel for masonry
22 D215837 Vacuum pump
23 D215859 Vacuum kit
24 D215835 Bracing bracket
25 D215852 Water collection ring
26 D215853 Spare seal for water collection
ring (10 pcs)

Assembly and adjustment

+
Also refer to your drill manual.
Mounting the drill (fig. B)
● Align the mounting holes in the bracket (29)
with those in the base of the machine.
● Insert a screw (30) into each of the mounting
holes and tighten securely.
● Carefully place the machine with the bracket
into the bracket holder (5) on the stand as shown.
● Tighten the bolt (31) using the feed handle (4).
Always mount your drill firmly to prevent
@
movement.
Installing the stand (fig. C - G)
The stand can be installed either vertically (fig. C)
or horizontally (fig. D) on a surface such as a floor
or a wall.
Always make sure the stand is securely
@
fastened on the surface.
Mounting the stand with the fastening set
(fig. E1 & E2)
A fastening set is required to secure the stand to
masonry (fig. E1) or concrete (fig. E2) surfaces.
● Locate the stand at the desired position and mark
the location of the mounting hole on the wall.
● Drill a hole at the marked location.
- In concrete: 15 mm diameter by 55 mm deep
- In masonry: 20 mm diameter by 85 mm deep
● Insert the anchor plug (32) into the hole.
● Tighten the anchor (33) into the anchor plug.
● Position the stand over the anchor.
26
● Place a washer (34) and wingnut (35) onto the
bolt. Securely tighten the wingnut.
Mounting the stand with the bracing bracket
(fig. F)
For a quick set up in indoor applications, a bracing
bracket can be used to secure the stand.
● Position the stand.
● Place the bracket foot (36) against the base (9).
● Move the latch (37) out of the way to depress
the lever (38). Extend the bracket (24) until it
reaches the opposite surface. Release the lever.
● Clamp the bracket in position using the rod (39).
● Insert the pin (40) into the hole closest to the
clamping mechanism.
Mounting the stand with the vacuum pump
(fig. G1 & G2)
If the stand is to be mounted to delicate surfaces,
a vacuum pump can be used to secure the stand.
The vacuum created in the base keeps the stand
securely in position.
This application works only if the stand
@
is mounted to a flat surface (e.g. tile,
vibrated concrete) which is clean and
free of debris and swarf. Otherwise,
the suction may drop, causing the stand
to fall or move.
● Fit the rubber seal (41) in the slot (42) in the
underside of the base.
● Place the vacuum handle (43) over the opening
in the base (9).
● Tighten the screw (44) with the washer (45) into
the handle.
● Position the stand.
● Connect the hose of the vacuum pump to the
connection point (16).
● Switch on the vacuum pump. Keep the pump
switched on as long as the application requires.
Adjusting the stand (fig. A)
● Read one of the air levels to check whether the
stand is level.
- Air level (11) for vertical applications
- Air level (12) for horizontal applications
● If adjustment is required, proceed as follows: