Attaching The Fan Blades - HAMPTON BAY Trieste El Manual Del Propietario

Attaching the
Fan Blades
1. Insert the blade through the slot cut-off in
the center flywheel, align the three screw
holes in the blade with the screw holes in
the flywheel and secure with the screws pro-
vided (Figure 9).
2. Repeat for the remaining blades.
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched.
The following procedure should correct most
fan wobble. Check after each step.
1. Check that all blade screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on
the ceiling. Measure this distance as shown
in Figure 10. Rotate the fan until the next
blade is positioned for measurement. Re-
peat for each blade. Measurement devia-
tions should be within 1/8". Run the fan for
10 minutes. If the fan continues to wobble
please contact Customer Service and a ba-
lacing kit will be sent to you at no charge.
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
Figure 9
OBJECTS BETWEEN ROTATING BLADES.
Figure 10
7.