Tips For Use - Thrustmaster ENZO FERRARI WIRELESS Manual De Instrucciones

WHEEL SETUP
Place the wheel on a table or flat surface.
1.
2. TABLE-TOP SETUP: Place the clamp screw into the clamp and then screw the clamping unit into the
hole on the underside of the wheel until firmly fixed into place. Be careful not to over-tighten the clamp
to avoid damaging either the clamp or the table.
3. KNEE-TOP SETUP: Place the clamp screw
unit into the hole on the underside of the wheel until firmly fixed into place.
Note: be careful not to over-tighten the clamp screw to avoid damaging the knee-top piece.
4. Connect the pedal connector cable
Note: in the event of malfunction during use due to electrostatic emission, please quit the game and
unplug the unit from the computer. Resume normal game play by plugging the unit back in and
restarting the game.
USB INSTALLATION
The USB connector allows you to hot-plug your wheel into your computer.
Start your computer up and plug the USB connector
your computer. Windows 98/Me/2000/XP will then automatically detect the new peripheral device.
Note: if you are connecting a USB peripheral device for the first time, Windows may ask you for the
Windows CD-ROM during installation in order to install the required system files.
• Under Windows 98: the Add New Hardware Wizard will find the appropriate drivers for you. Simply
click on Next and then follow the on-screen instructions to complete the installation.
• Under Windows Me/2000/XP: installation of the drivers is carried out automatically.

TIPS FOR USE

The RESET button enables you to recalibrate your wheel.
The radiofrequency's maximum range is 30 feet (9 meters). In order to optimize the quality of radio
transmissions and enjoy the maximum range for your product, we recommend that you place your receptor
as high up as possible. Example: place your receptor on top of your PC case, as opposed to on the floor.
Your Enzo Wireless wheel automatically switches to standby mode after 5 minutes of not being used.
Press the RESET button to resume gameplay.
If you disconnect the analog pedals during a game, your Enzo Wireless wheel may start acting strangely or
may not react at all. You should therefore proceed as follows:
1. Press START to pause your game.
2. Disconnect the analog pedals.
3. Press RESET.
4. Return to your game.
Make sure to set the channel selector switch
use. This will help to conserve power and extend battery life.
If your Enzo Wireless wheel starts acting strangely:
1. Switch off the wheel and then switch it back on again using the channel selector switch
the underside of the wheel.
2. Press RESET Button simultaneously.
into the hole in the knee-top piece and then screw the
to the pedal receptor cable .
into one of the USB ports located at the back of
on the wheel to the OFF position when the wheel is not in
3/6
located on