Setting The Date And Time - Graham Field LUMISCOPE 1133 Manual De Instrucciones

This function provides accurate measuring time for
each measurement. To get an accurate date and time,
preset the date and time correctly before the first use
of this device.
The operation procedure for presetting Date/Time is
as follows:
1. When the device is connected to power supply at
first, the display will show as in Fig.3;
2 Press and hold the button 'M1', then press the
button ' ' , and the year number flashes as
shown in Fig.4;
3. Press button 'M1',or 'M2' to subtract or add the
number, and press button '
4. When the year setup is finished, the month number will flash automatically.
Follow the same instruction as above to set month, date and time;
5. Press button '
and time, repeat steps 2,3,4.
Note: When under the mode of Date/Time setting without any
operation, the device will automatically return to standby mode after
one minute.

SETTING THE DATE AND TIME

' for confirmation;
' to finish the setup. If you wish to change the date
10
Fig.3
Fig.4